So I have a digit map set to the following on 4 IP7000s
[2-9]11|0T|011xxx.T|9[2-9]xxxxxxxxxT|9[0-1][2-9]xxxxxxxxxT|[1-9]xxxT|**x.T
I'm having issues with the 10 or 11 digit dial not timing out and dialing on it's own, the customer has to hit "dial" to place the call. How can I enable the time out correctly for these?
Also, I am planning to change the digit map to the below as I thought about it more and realized I had a few "errors".
[2-9]11|0T|011xxx.T|9[2-9]xxxxxxxxxT|91[2-9]xxxxxxxxxT|[1-8]xxxT|**x.T
9[2-9]xxxxxxxxxT should allow them to the trunk access code of 9, then a 10 digit number starting with 2-9 and have it dial after the timeout correct?
91[2-9]xxxxxxxxxT should allow them to dial the trunk access code of 9, then 1 and 10 digits starting with 2-9 and have it dial after the timeout correct?
[1-9]xxxT does allow them to dial an extension without hitting dial so I am just baffled why the other lines do not work in the same manner. I wonder if my corrected digit map will fix this but I am unable to make the change at this point since it requires a reboot of the phones.
These all are currently running the latest 4.0.11.0583 UC software
Thanks!